We pushed really hard to get the bronze floors finished up so they could be sitting in their places during the open house. In this episode we show how we got the floors ready to start fabricating the supports for the engine beds. Since everything fits in such a small space here and has to be fairly precise, we had to work on fabricating the floors while working wit the actual engine beds we are going to install. We therefore worked on each piece simultaneously to end up with a perfect fit.
The stern floors are so much higher in order to be at an appropriate height to accommodate and support the engine which also meant very large wings up the frames. If the ones down the rest of the center line took a while, these were that much more time consuming again! To put the correct twist and bend in a piece of bronze strapping one half inch thick by twenty four inches in length on a small A-frame press was challenging to say the least!
Thank you for following along and supporting our endeavor and we would like to thank everyone that came to our Open House! We had a blast!
____________________________________________________________________
Acorn to Arabella wishlist: http://www.acorntoarabella.com/acorn-...
Total Boat referral code: http://totalboat.refr.cc/steveandalix...
FOLLOW US:
Patreon: https://www.patreon.com/acorntoarabella
Instagram: https://www.instagram.com/acorntoarab...
Facebook: https://www.facebook.com/acorntoarabella
Website: http://www.acorntoarabella.com
Fitting the Engine Beds - Acorn to Arabella watershed | |
| 5,740 Likes | 5,740 Dislikes |
| 132,053 views views | 123K followers |
| People & Blogs | Upload TimePublished on 17 May 2019 |
Không có nhận xét nào:
Đăng nhận xét